Ford order page

Top of this page

Back to Ford
intro page

Ford order page

Top of this page

Back to Ford
intro page

It only takes a screwdriver and 10 seconds to break in...unless you have the Jimmi' Jammer™ installed.

Stop Thief!

Super Duty trucks are vulnerable by prying under the handle or by punching the lock cylinder into the door.

It's fast, easy and doesn't attract much attention.

The Jimmi' Jammer™ for Ford Super Duty trucks prevents thieves from getting at the lock rods inside the door or punching the lock into the door.

Scroll down to see how the Jimmi' Jammer™ works on your truck...

<< A Jimmi' Jammer™ plate in place, protecting the lock.

This photo shows a Jimmi' Jammer™ plate installed inside a Ford Super Duty door.

The lock rod is removed for the picture so you can see how the plate surrounds the lock holder, providing added strength to the handle assembly.

The circular clamp comes with the kit and adds further strength to the lock holder.

What about the rear doors on a four door truck?

Your back doors are vulnerable too! >>

Thieves have figured out how to get at the rods inside the door cavity on rear doors by pulling the bottom of the handle away from the body metal and using a piece of wire or screwdriver to move the internal rods.

This same method is used on passenger side front doors that do not have a lock cylinder. Put a plate on each door!

Important Information: Some Super Duty owners are replacing front door handles with rear handles to eliminate the lock cylinder. While this is a good visual deterrent, most thieves already know how to get in even though no lock is present.

If you replace your handles, you still need the Jimmi' Jammer™ to keep the thieves out!

Above: Inside a rear door the latch area is vulnerable right below the door handle.
The Jimmi' Jammer™ blocks access to this area.

Each Jimmi' Jammer™ kit comes with everything needed:

- Jimmi' Jammer™ plate for each door
- Circular clamp for each lock holder
- Window warning labels
- Step by step instructions
Note: Each kit comes with two plates. Front and rear kits sold separately.

PN 103001 fits 1999 and newer F250/350/450 Super Duty trucks with lock cylinder on drivers door only. (Passenger side plate will not have a hole for the lock. See photo) >>

PN 103002 fits 1999 and newer F250/350/450 Super Duty trucks that have a lock on each front door.

PN 103010 fits the rear doors on a four door truck. You can also use this kit when you replace your front handles with rears. Just be sure to put a plate on each door!

PN 113475 fits the tailgate handle on 2008 and newer Super Duty trucks.

PN 5471 guards the hood latch on 1999 and newer Super Duty trucks that do not have a second radiator or transmission cooler in front of th latch. Click in box below for details.